eSUN Water Washable Resin Svart – 0,5 kg

INNAN ANVÄNDNING: Läs säkerhetsdatablad HÄR, samt “Försiktighetsåtgärder” nedan.

Innan du beställer eSUN resins till din LCD 3D printer, se till att UV-våglängden din skrivare använder är 405nm. Detta resin är av leverantören grundligt testat och kompatibelt med bland annat Anycubic Photon och Wanhao D7.

299 kr

I lager

Försiktighetsåtgärder:
1. Förvaring
a) Förvara mörk och förslutet i rumstemperatur
b) Det är rekommenderat att förvara resin mellan 15 – 35 grader i dess originalförpackning
c) Undvik dammiga och fuktiga miljöer

2. Användning:
a) Skaka väl före användning. Undvik direkt solljus under användning.
b) Förvara oåtkomligt för barn. Får ej förtäras.
c) Använd ALLTID handskar och undvik direkt kontakt med hud.
d) Använd i väl ventilerat utrymme
e) Vid kontakt med hud, skölj omedelbart med rikliga mängder vatten. Sök läkarvård vid behov.
f) Färdiga utskrifter behöver tvättas med högkoncentrerat alkohol (>95%) ca 30 sekunder.

Brottförlängning

Densitet

Draghållfasthet

Fabrikat

Färg

Färgegenskap

Färgnamn

Material

Materialvariant

Vikt

Tillverkarens artikelnummer

Shore hårdhet (D)

Våglängd

Viskositet

1 recension av eSUN Water Washable Resin Svart – 0,5 kg

  1. Daniel (verifierad ägare)

    This was my first resin with my first resin printer and I have not complaints about quality (i have nothing to compare to though), it being water washable is great too. However, a WARNING must follow.
    The bottle says to shake well before use- DO NOT SHAKE UP AND DOWN and if you happen to do it that way, wait a long while before you open the bottle.

    What happened to me is i shook the bottle, filled the vat and then put the cap on, screwed it tight, put bottle back in it’s protective inflated plastic thing and then back in the cardboard box i got it in (lying down, unfortunately, might have gone better if it was standing up. When i opened it two days later i found the box full of resin.

    What seems to happen is resin gets stuck in the cap and in the bottle thread, when you screw the cap it start slowly seeping out. When i today used the resin again and found the problem i wiped the bottle down carefully after i recapped it, only to find more resin kept seeping out and i had to wipe it down several more times. Luckily I have a curing chamber so i will have to cut the box and everything else into pieces to cure it one piece at a time. Terrible design for the bottle, good resin.

    On a related note- does anyone know how dangerous this water-washable stuff is? First time i used it i was dissapointed to note a strong smell even though i have my printer in an enclosure with a strong fan pulling air through a window- i now realize it was the cardboard box soaking in resin for a couple of days.

Lägg till en recension

preloader